What problems should be paid attention to when transporting color steel plates？

The following points should be paid attention to during the transportation of color steel plates:

1. Vehicle selection

The selection of vehicles to transport goods should be based on the standard size varieties of the wall panels of the machine room to select the appropriate type of transport vehicles.

Generally, large special trailers are used for transportation.

When loading the color steel plate wall panel,

the machine room wall panel and accessories should be installed in advance according to the type and variety and other conditions,

and the binding should be strong and stable to prevent the metal surface from being worn or scratched.

2. Fixing of color steel plate

During transportation, the machine room wall panel should be securely tied to the car,

and temporary fixing methods such as wooden wedges should be used to prevent the occurrence of loosening and kneading deformation caused by the shaking of the car body,

and then reduce the appearance of the metal.

Or the chance of scratching.

When transporting color steel plates,

pay attention to whether the height of the transport plates exceeds the length of the trailer,

and perform corresponding operations to prevent overturning.

When the color steel plate is to be tied to the machine room wall panel on the car, the angle steel or the angle iron with the same plate length should be selected at the corners of the two ends of the top floor machine room wall panel.

This can evenly distribute the pressure of the rope binding and prevent the pressure from gathering. Damage the edge of the wall panel of the mill room.

3. Choice of placement

In the case of long-distance transportation or poor road conditions,

the metal-faced computer room wall panels are required to be placed horizontally.

When the color steel plate is transported to the special wall steel plate of the machine room,

the length of the steel wall plate should not be greater than 1.0 meters to ensure that the material will not be deformed and worn.

If there is a wall panel that exceeds 2 meters,

pick out the corresponding panel and tie it all at the rear to prevent the wall panel of the engine room from being damaged by the excessive deflection caused by the wave shock at the rear of the car.

When the color steel plate is transferred,

both ends should be lifted together to avoid damage to the surface oxide film or coating.